1. There is no need to feed the material during debugging, but the guide screw on the guide plate must be adjusted upwards, and then the hammer of the punch press is slowly adjusted to the bottom dead center by inching. down too low, otherwise the floating rod will bend or break.
2. When starting the cross-cutting machine to work continuously, the speed adjustment screw of the feeder must be rotated clockwise, and the slider movement is slightly slower, so that it can be seen whether the nylon gasket and the length fine-tuning screw are encountered during the reciprocating movement of the slider.
3. During the test run, the slider moves back and forth. If it only touches the nylon gasket and does not touch the length fine-tuning screw, it is because the floating rod is not lowered deeply enough, and the guide screw on the punch needs to be lowered slowly.
4. If the cross-cutting machine only touches the length fine-tuning screw and does not touch the nylon spacer when the slider moves back and forth, it is because the floating rod descends too deep, and the guide screw on the punch needs to be slowly adjusted upwards.
5. Agar slayder uzunlikdagi nozik sozlash vinti va neylon yuvish mashinasi o'rtasida harakatlansa va ikki tomon orasidagi masofa teng bo'lsa, bu vaqtda slayder tezligini normal holatga keltirish uchun tezlikni sozlash vintini soat miliga teskari yo'nalishda aylantirish kerak. , va slayderni o'zaro harakat qilish uchun. Neylon ajratgich va ajratuvchi halqa.
6. Kesish mashinasining tezligi bir xil bo'lib qolsa va oziqlantirish masofasini uzoqdan qisqasiga o'zgartirish kerak bo'lsa, avval suzuvchi novdaning pasayish masofasini kamaytirish uchun hidoyat vintini yuqoriga sozlang va keyin tezlikni sozlash vintini aylantiring. soat yo'nalishi bo'yicha, oziqlantirish zımbalama tezligiga mos kelishi uchun.
7. Kesish mashinasining tezligi o'zgarishsiz qolsa va oziqlantirish masofasini qisqa vaqtdan uzoqqa o'zgartirish kerak bo'lsa, avval suzuvchi novdaning tushish masofasini oshirish uchun hidoyat vintini pastga tushiring va keyin tezlikni sozlash vintini soat sohasi farqli ravishda aylantiring, oziqlantirish zımbalama tezligiga mos kelishi uchun.
